If you crack the front panel on your iPad, you can either live with it, buy a new one, or fix it.
For those with an AppleCare+ or other warranty that covers accidental damage, the choice is obvious. Get the unit fixed or replaced. If your iPad isn’t under warranty, you don’t want to buy a new one, and you’re ready to tackle a challenging, but satisfying do-it-yourself fix, here’s a guide for replacing the front panel.
This article was originally published on CNET’s How To blog.
Before you tackle this fix
Before you tackle this fix, I encourage you to watch my video on what to know before trying to fix a smartphone or tablet. It will help you decide if you should tackle the repair yourself or take your iPad to a shop.
And lastly, understand that by following the instructions in this video, you do so at your own risk. Neither CNET nor any of its representatives can be held responsible for injury, damage, or loss of data.
Getting replacement parts and tools
Before you begin, you’ll need to get the necessary replacement parts and tools. For this fix, we’re just replacing the front panel–not the LCD. We’ll be reusing the Home button and camera bracket from the old panel, as they aren’t damaged.
You can buy replacement panels online for between $50 and $150 dollars. Just be sure that you buy the right one for your iPad. And depending on where you buy the panel, it may come with pre-cut adhesive strips. If it doesn’t, you’ll need to buy them or cut your own strips from double-sided tape.
As for tools, you’ll need a hair dryer or heat gun, a few thin metal blades, several plastic spudgers, guitar picks, or plastic case opening tools, and a Phillips #00 screwdriver. Again, you can pick these up online if you don’t have them.
Lastly, I’m using an iPad 2 as the guinea pig in this article. But, the same basic steps can also be used to replace the front panel on the iPad 3.
1. Backup your data
Just in case anything goes wrong during the fix, you should backup all the iPad’s data using iCloud or iTunes.
2. Remove the broken panel
With your data safe, heat the panel’s edges with the hair dryer or heat gun. This loosens the adhesive that holds the panel to the iPad’s metal case. Heat a small area until you can easily insert a thin tool between the panel and case. Gently pry them apart. If the panel doesn’t easily come away from the case, keep heating the area. Also, take care not to insert the tool too far into the iPad as this can damage the LCD and other internal components.
Once you’ve created a small gap in one area, work your way around the edge–heating and prying as you go. You’ll need to leave placeholders (like a plastic spudger or guitar pick) in the separated sections, to prevent the panel and case from sticking back together.
You’ll also need to be very careful when working to right of the Home button. The Wi-Fi antenna is attached to the panel here, and you’ll need to gently pry it loose without damaging it.
Take care around the panel’s bottom left corner. The panel’s digitizer cable located here and you don’t want to damage any other internal components by carelessly yanking it loose.