Discussion on:

Asterisk Open Source PBX

I have an Asterisk Server and have a Digium TDM400p PCI board which the box fails to load

When I issue the command dahdi_cfg nothing gets returned
When I issue the command dahdi_genconf I receive
empty configuration -- no spans
empty configuration -- no spans
When I issue the command dahdi_hardware if receive
driver should be "wctdm" but is actually "netjet"
pci:0000:02:00.0 wctdm+ e159:0001 Wildcard TDM400P REV I

How do I fix this so the board is usable in PBX in a flash?

Try reposting this in the 'Q&A' forum. The 'Discussion' forum is for matters of general discussion, not specific problems in search of a solution. The 'Water Cooler' is for non-technical discussions. You can submit a question to 'Q&A' here:

http://www.techrepublic.com/forum/questions/post?tag=mantle_skin;content

There are TR members who specifically seek out problems in need of a solution. Although there is some overlap between the forums, you'll find more of those members in 'Q&A' than in 'Discussions' or 'Water Cooler'.

Be sure to use the voting buttons to provide your feedback. Voting a '+' does not necessarily mean that a given response contained the complete solution to your problem, but that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours. If they have a ready source of reference available, perhaps won't need to repeat questions previously asked and answered. If a post did contain the solution to your problem, you can also close the question by marking the helpful post as "The Answer". .