I have WAN/LAN circuits.
They are all Cisco. The core router (usually 7200 series, 7206) is interfacing with the carrier's WAN cloud (T1, T3, DS-3, OC-3, etc) and connected to core switch (Cat 6500 series, 6509) from the other side. In some cases, the distribution layer switch is Cat 4506 or 3550 with VLAN implementations. The access switches are usually Cat 3550.
Once I telnet to core switch and logged in (which is preferred), how do I get to port(s) on the access switch(es) and shut down or unshut ports to certain hosts?
What are the Cisco commands/steps I have to use to get to the ports?
Your help is appreciated.
Thanks
- Follow via:
- RSS
- Email Alert
Question
0
Votes
Answers (3)
0
Votes
CCNP or CCIE?
I'm gonna be blunt. If you don't know how to navigate or use Ciscoworks configuration software, you shouldn't be in there mucking with it.
30th Oct 2006
0
Votes
Just saw it was unanswered
1.) en,sh mac address-table, Find port, and identify with node
2.) cont f, go to interface
3.) turn off
2.) cont f, go to interface
3.) turn off
Updated - 23rd Mar 2007
0
Votes
your
edited by moderator
Message was edited by: beth.blakely@...
Message was edited by: beth.blakely@...
Updated - 23rd Mar 2007
