General discussion

Locked

Access 97, print range over 3 characters

By mbps13 ·
I'm working on an NT 4.0 machine with SP6a installed and using Access 97. The problem is inserting a page range that is over 3 characters. Access stops after the third character and will not accept any more. I've been able to print on a 95 & 98 machine with no problem. I started out on SP5 and added the latest SP hoping for the best. No luck. The only work around i've found is to create a macro, but there has to be a fix, regedit ?, around some where. Also , it is not limited to one machine. I've tested four other similar NT machines with the same results.

This conversation is currently closed to new comments.

7 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Access 97, print range over 3 characters

by mtg289 In reply to Access 97, print range ov ...

Sounds like a problem with the NT software. Try going to the Microsoft Site and checking for problems with SP and printing, there may be a patch for it. If not try emailing Microsoft to let them know

Collapse -

Access 97, print range over 3 characters

by mbps13 In reply to Access 97, print range ov ...

The question was auto-closed by TechRepublic

Collapse -

Access 97, print range over 3 characters

by PrinterManager In reply to Access 97, print range ov ...

It?s old you should re-post.

Collapse -

Access 97, print range over 3 characters

by mbps13 In reply to Access 97, print range ov ...

The question was auto-closed by TechRepublic

Collapse -

Access 97, print range over 3 characters

by soporte_ms In reply to Access 97, print range ov ...
Collapse -

Access 97, print range over 3 characters

by mbps13 In reply to Access 97, print range ov ...

The question was auto-closed by TechRepublic

Collapse -

Access 97, print range over 3 characters

by mbps13 In reply to Access 97, print range ov ...

This question was auto closed due to inactivity

Back to Windows Forum
7 total posts (Page 1 of 1)  

Operating Systems Forums