General discussion

Locked

ArcServe across routers

By techrep ·
We support a banking system with a TCP/IP network that is WAN'd across the local branches by Cisco 3600 routers. We are trying to get the ARCSERVE at the main branch to back up the clients in the remote locations. Some are on T-1, some are 56K Frame, I have put static routes in the Cisco 3600's and I can ping out to the branches from the Arcserve machine, but the ArcServer software does not see them. I have installed the client software and brought that machine to the local subnet and it seesit OK.

Any ideas?

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

need more info

by road-dog In reply to ArcServe across routers

Assuming that the devices are configured to transport over IP, you must verify IP connectivity END-to END. If IP is working fine, (PING will do to verify layer 3 is OK) then you may want to see if your clients are working ok. Put a client on the same subnet as the server if you have to to remove the network from the equation. You may want to put a SNIFFER on the network and capture a session. That may tell you if the conversion to IP is actually working, and possibly where in the connect process thinhs are failing...

hope this helps.

Collapse -

Try the CA helpdesk

by DavidMartin In reply to need more info

Give the CA ARCserveIT help desk a ring - they have always been great at solving my problems

Back to IT Employment Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums