General discussion

Locked

"Drive not ready"

By azbrushape ·
I am having trouble "reaching" a WD Enterprise WDE9100 ultra fast wide SCSI 3 HDD. It only returns the error msg, "drive not ready". What is wrong,(my fault?)? All pin connectors are properly placed, I believe, altho I do NOT have a pin connections read-out. It is one of two I recently received, and after buying a new controllor card, the other is operating normally.
can anyone suggest an answer? thanks.
AZBRUSHAPE@AOL.COM

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by TABComputers2002 In reply to "Drive not ready"

Has the drive ever been able to be read? It's possible your drive was bad from the start.

Collapse -

by azbrushape In reply to

I agree. The drive has run VERY hot. The same procedures were used to put both the drives in service, but this one did not come up.

Collapse -

by azbrushape In reply to "Drive not ready"

This question was closed by the author

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums