Question

Locked

How do configure a cisco 881 router for remote management via the wan por?

By mlehr ·
I need to remotely make changes to a cisco router 881 using CCP. How do I configure the router for this?

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Do you just need CLI access?

by robo_dev In reply to How do configure a cisco ...

If you just need CLI access, then configure enable SSH and create a NAT rule for that and you're done.

Depending on where you connect from, you might want to create an ACL for a particular IP address or use a non-standard SSH port for additional security.

see the guide below for the config:
http://www.cisco.com/en/US/tech/tk583/tk617/technologies_tech_note09186a00800949e2.shtml

NOTE:

Looking at your current config, above, you've posted your router username and the hash of both your device and enable passwords on the Internet :) (so you might want to change those). You also posted your dyndns username AND your domain name, so an attacker knows what door to knock on. I can also see the NAT rules which show what ports are open AND the internal IP address of each server. I am not trying to be snarky here, but really that's making an attacker's job a lot easier.

Collapse -

Reponse To Answer

by mlehr In reply to Do you just need CLI acce ...

Thanks for the heads up! and the link.

Back to Networks Forum
3 total posts (Page 1 of 1)  

Hardware Forums