Question

Locked

i have a easynote F0336-v089 Packard Bell notebook usb port don't work

By ironblasterjrom ·
after i upgraded into a windows 7 the usb port of my Packard Bell easy note f0336-v089 stop functioning , i look on the device manager all device driver signing in ,, what seems the problem of this.. any help from the expert.....

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

64-bit system?

by TobiF In reply to i have a easynote F0336-v ...

Did you upgrade to a 64-bit system?
Then pray that someone has written the needed drivers for 64-bit systems.

I went here, but had problems searching, knowing too little about your box:
ftp://ftp.download.packardbell.com/NOTEBOOK/

EditAdd:
Oh, If your box is not regarded as legacy, then you might even find it here:
http://www.packardbell.co.uk/pb/en/GB/content/download

Collapse -

Or you can try the Unknown Device Identifier free from here

by OH Smeg In reply to i have a easynote F0336-v ...

http://www.fileheap.com/software-unknown-device-identifier-download-34861.html

To make sure which Chip Set is involved for the USB Ports and then try to find drivers for them that suit your OS.

What I would have suggested before installing 7 was to test the Hardware with the Windows 7 Upgrade Adviser to see if your Hardware was actually supported by Windows 7.

http://www.microsoft.com/downloads/details.aspx?displaylang=en&familyid=1b544e90-7659-4bd9-9e51-2497c146af15

Col

Back to Networks Forum
3 total posts (Page 1 of 1)  

Hardware Forums