General discussion

Locked

Need outgoing IPSec for MUVPN config

By SQL Dude ·
Hello all,

Scenario:
In the interest of securing an application using MS SQL replication, I am rolling out a mobile VPN client to each of my client's SQL Servers. I am using a Watchguard Firebox 700 / III runnning v7.2 as the VPN host. I am using the Watchguard MUVPN lite 6.13 client. I am forcing virtual adaptor and ESP tunnels (No PPTP). This is successfully in producition in four sites.

Problem:
I have a client that cannot connect using the VPN client software. They have a Cisco PIX Firewall Version 6.3. I believe they are not allowing outgoing IPSec connections correctly. Additionally, they are using their PIX to terminate VPNs for their office. (I do not have details on this).

I have verified that the certificate I generated for them will work correctly from an outside source, so I am sure my configuration is correct.

Question:
Does anyone have information on configuring a PIX to allow IPSec to pass through without hurting their existing VPNs? Their Net Admin is a rookie and I am a developer. We are both Cisco impaired.

Thanks,

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by mikex In reply to Need outgoing IPSec for M ...

I hope this will help you:

http://www.ietf.org/html.charters/ipsec-charter.html

You must use UDP ports to do that

Collapse -

by mikex In reply to
Collapse -

by SQL Dude In reply to

Thanks,

Good Info

Collapse -

by SQL Dude In reply to Need outgoing IPSec for M ...

This question was closed by the author

Back to Networks Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums