General discussion
-
CreatorTopic
-
March 28, 2000 at 12:33 am #2081770
pc will not boot up on good hd
Lockedby patrick_wood · about 24 years ago
i know the hd is good because it worked on another pc
will allow you to install win 95 then when you reboot
will say invalid sys diskboth pcs have same board, mem, cards
board is 486 dx2, amd
Topic is locked -
CreatorTopic
All Comments
-
AuthorReplies
-
-
March 28, 2000 at 1:08 am #3901453
pc will not boot up on good hd
by moflic · about 24 years ago
In reply to pc will not boot up on good hd
Most likely you have a bad memory chip. Switch SIMMs from the working computer just to make sure, or boot from a diskette with device=himem.sys /testmem:on in config.sys. Try also changing the memory access times in CMOS setup>chipset setup.
Could be also a boot sector virus, or the virus protection activated, but in general win95 displays a warning that you should disable virus protection from CMOS setup.
Also do a
fdisk /mbr
to rebuild the MBR. Perhaps windows cannot write it properly.-
September 20, 2000 at 7:03 pm #3734956
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 1:40 am #3901450
pc will not boot up on good hd
by dmiles · about 24 years ago
In reply to pc will not boot up on good hd
Boot the computer into safe mode select to the step-to-step configurartion and select yes to all.reboot the computer.make sure the HIMEM.,line has a y at the end
-
September 20, 2000 at 7:03 pm #3734957
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 2:19 am #3901447
pc will not boot up on good hd
by shadow · about 24 years ago
In reply to pc will not boot up on good hd
1- Check Your Bios settings and make sure that the disk is recognized and is selected as the 1st bootable drive.
2- Run Scandisk to make sure you do not have any bad sectors that are hanging out on your boot partition. If it finds bad sectors letit mark them as bad.
GOOD LUCK!!
-
September 20, 2000 at 7:03 pm #3734958
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 2:24 am #3901446
pc will not boot up on good hd
by chrusher9 · about 24 years ago
In reply to pc will not boot up on good hd
All your data should be transfered to another drive before proceeding. On the older 486 units you need to make sure that the BIOS can support the drive you are installing. If you can get to the CMOS see if it is reading the drive correctly. Format the drive using the old relaiable fdisk /s command after you have partitioned the drive. The partitioning will create an active partition, and the format will load the COMMAND.COM IO.SYS AND MSDOS.SYS. After that you should be able to load your the drive with a new OS. Good luck!
-
September 20, 2000 at 7:03 pm #3734959
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 2:49 am #3901440
pc will not boot up on good hd
by csheltcomp · about 24 years ago
In reply to pc will not boot up on good hd
If you did a recent fdisk and set up new partitions, please make sure that the primary partition is set active in the status.
-
September 20, 2000 at 7:03 pm #3734960
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 2:56 am #3901439
pc will not boot up on good hd
by shawkengin · about 24 years ago
In reply to pc will not boot up on good hd
Most of the answers posted will help. But one you need to check will be that the hard drive is still recognized in the BIOS/CMOS. Sounds like the HDD settings are missing each time you reboot the system. That is an indication the the CMOS battery isbad/weak. Change the battery with the same known good board you mentioned and see if the HDD boots up. Good luck.
-
September 20, 2000 at 7:03 pm #3734961
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 5:04 am #3896521
pc will not boot up on good hd
by bdgray · about 24 years ago
In reply to pc will not boot up on good hd
Just copy the system files to the HD using a good WIN95 boot disk.
i.e.
SYS C:Did you use Ghost? Sometimes you have to SYS a drive after ghosting it.
-
September 20, 2000 at 7:03 pm #3734962
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 6:01 am #3896518
pc will not boot up on good hd
by lee v. · about 24 years ago
In reply to pc will not boot up on good hd
Some 486’s have a BIOS that will only recognize up to 500 or perhaps 528MB of a hard disk, even if it seems to be recognizing the whole disk and the appropriate parameters are displayed. You may need to use disk management software from the hard disk manufacturer to trick the BIOS into thinking the appropriate number of sectors and cylinders exist. Western Digital’s is called EZ Drive, Seagate’s is DiskWizard, etc.
-
September 20, 2000 at 7:03 pm #3734963
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 28, 2000 at 9:29 pm #3896496
pc will not boot up on good hd
by hasse mcse/brainbench · about 24 years ago
In reply to pc will not boot up on good hd
Hi!
If your BIOS supprts the HD then follow theese steps and 95 will boot up.
If BIOS dosen’t support your disk get some disk management software as suggested in previous answer.
1. boot with DOS disk and remove all partitions.
2. REBOOT
3. boot with DOS disk and make a primary partition that is 1024Mb if this dosen’t work try 512Mb instead.
4. REBOOT
5. boot with DOS disk and format partition.
6. Install Win95 and when done Win95 will be up and running.
7. Now go to dos prompt from Win95 and create any additionla partitions you want./Hasse
-
September 20, 2000 at 7:03 pm #3734964
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 30, 2000 at 8:54 am #3896376
pc will not boot up on good hd
by riyaz · about 24 years ago
In reply to pc will not boot up on good hd
If I were u;
I will make sure the hard disk jumper is master.
cd-rom is secondary. (better for performance)
if it’s connected with a Atapi cd-rom make hd jumper master & slave present
I will detect the harddisk from BIOS.
Save & exit
Boot from Diskmanager. offcourse virus free & protected. also with win95 system. not ontrack bootloader.
run DM /x
/x option is to avoid diskmanager detecting the Hard Disk Brand because I do not know the Harddisk model also it’s little hard to get exact diskmanager for the harddisk.
use manual installation & create partion.
this will format & transfer the 95 system to c: driveinstall cd-rom if u have.
if u are using diskette version please check for virus with mcafee 4.0 or latest. make sure CD version is OEM or Orginal Copy from Microsoft, other wise check viruses for cd also. (it’s on the internet mcafee.com)Install & configure your plug & play cards configurations with the utility comes with P&P cards, ex: Creative SB
insta
-
September 20, 2000 at 7:03 pm #3734965
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
March 31, 2000 at 12:43 am #3896337
pc will not boot up on good hd
by frank.duffey · about 24 years ago
In reply to pc will not boot up on good hd
This Problem has nothing to do with your hardware.
This is a software related issue:
1.) check Format of your HDD (Fat 32 or fat 16.
2.) Did you FDISK the drive and remove the current partition?
3.)Did you make the partition active?
4.)Did you check the drive for a Virus using a Win 95 Boot disk and a Virus Scan Such as PCScan from PcCillian in a dos mode.
And Finally try using this command with FDISK:
A:\FDISK/MBR
4.)FDsik should be on your Win 95 Setup Disk.
Hope this helps ypu out.
FD Networking
Frank E Duffey-
September 20, 2000 at 7:03 pm #3734966
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
April 19, 2000 at 4:21 pm #3899691
pc will not boot up on good hd
by tysonmathews · about 23 years, 11 months ago
In reply to pc will not boot up on good hd
NO NO NO NO
go into you CMOS AKA BIOS and change your Boot up order.
It may either not be set to boot C or you have the 3 1/2″ boot floppy still in and it is set to boot A,C or A,CD ROM,C and there is a CD in.
on boot up hit delete or what everit states to enter setup. THAT IS THE DEAL!-
September 20, 2000 at 7:03 pm #3734967
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
April 19, 2000 at 4:24 pm #3899690
pc will not boot up on good hd
by tysonmathews · about 23 years, 11 months ago
In reply to pc will not boot up on good hd
Do not format do not change your ram do what my last post stated. everything is fine. it is your boot up order or you have a 3 1/2″ floppy in or a CD Rom in still and it is set to boot those. WIN95 CD ROM is not bootable
Just follow my last post to you.-
September 20, 2000 at 7:03 pm #3734968
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
May 9, 2000 at 8:38 am #3898899
pc will not boot up on good hd
by eswoodland · about 23 years, 10 months ago
In reply to pc will not boot up on good hd
The above answers are all good places to check. This may sound a little elementary, but after formatting the drive, did you sys it? Boot from a Win9x bootdisk and from the a:> prompt, just type sys C: then reboot w/out the bootdisk. Hope this helps!
-
September 20, 2000 at 7:03 pm #3734969
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
May 12, 2000 at 8:39 am #3896042
pc will not boot up on good hd
by vmm · about 23 years, 10 months ago
In reply to pc will not boot up on good hd
Let’s assume, your HD has write troubles on initial tracks. Try to reallocate starting cylinder of your boot logical disk (C:) from 0 to, say, 1st one (using DM for instance). This may have an additional benefit in protection from damage to your data from e.g. occasional writes staring with CHR 0-0-1.
-
September 20, 2000 at 7:03 pm #3734970
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
The question was auto-closed by TechRepublic
-
-
September 20, 2000 at 7:03 pm #3734955
pc will not boot up on good hd
by patrick_wood · about 23 years, 6 months ago
In reply to pc will not boot up on good hd
This question was auto closed due to inactivity
-
-
AuthorReplies