General discussion

Locked

Texas Instruments Microlaser error messa

By itsamadworld ·
This printer has a problem when I change out the toner cartridge. I keep getting a "replace waste toner bottle" message but have already changed out the waste toner bottle. TI gave me a work around for this one time, but unfortunately, I've lost the instructions.

Does anyone know about this?
Thanks,
B. Sloan

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Texas Instruments Microlaser error messa

by david.r.smith In reply to Texas Instruments Microla ...

When you replace the toner cartridge you also need to replace the waste toner bottle which contains a fuse. If you did that, and you're receiving that error message then reset the fuse flag by:
Turn off the printer power.
Press and hold SELECT and PRINTER SETUP and turn on the printer power.
When the display shows PCU DIAG MODE, release both keys.
Press and hold UP and PREVIOUS at the same time.
When the display shows FUSE FLAG RESET, release both keys.
Turn off the printer power.Turn on the printer power and resume normal operation.

Collapse -

Texas Instruments Microlaser error messa

by itsamadworld In reply to Texas Instruments Microla ...

Poster rated this answer

Collapse -

Texas Instruments Microlaser error messa

by itsamadworld In reply to Texas Instruments Microla ...

This question was closed by the author

Back to Desktop Forum
3 total posts (Page 1 of 1)  

Hardware Forums