Question

Locked

Two vlans with Internet but without 802.1q?

By njcsamuels ·
We're looking to add a second vlan on a cisco catalyst (L3). Our firewall is not cisco and does not support 802.1q. Is it possible to setup both vlans with internet access?

I'm thinking the following link describes a way to do it. But our firewall also doesn't support eigrp so i was going to manually setup the routes.

http://www.thebryantadvantage.com/CCNPCertificationBCMSNExamRoutedPorts.htm

edit - others are syaing this cant be done without 802.1q

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

i tried it

by njcsamuels In reply to Two vlans with Internet b ...

i was able to setup the routed port on the catalyst. then i was able to ping from the catalyst to the firewall connected to the routed port. However, I could not ping the public addresses beyond the firewall.

When I reset the config, which effectively takes off the no switchport, then i can ping the public addresses. I dont understand why.

Collapse -

no default route

by njcsamuels In reply to Two vlans with Internet b ...

i needed to add a default route using
ip route 0.0.0.0 0.0.0.0 192.168.1.1

i had the default gateway set and thought these two commands were one in the same.

Back to Networks Forum
3 total posts (Page 1 of 1)  

Hardware Forums