Question

Locked

win Xp installation, doesn't see the sata drives. Bios sees the drive.

By merced.a ·
I can bring up the syst.with an ide drive. Windows come up ok, but it still doesn't see the sata drives. I changed the sata drive and the cable. Pls. help.Thanks

This conversation is currently closed to new comments.

8 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

You need SATA drivers ...

by OldER Mycroft In reply to win Xp installation, does ...

Which you'll find by looking on the manufacturer's website, of whichever motherboard/chipset you are using. You may have to specify the make of the SATA drive(s) too.

XP didn't install with default SATA drivers, having been developed before SATA hard disk drives had been born.

Collapse -

Previous post about drivers are correct....

by Bapster In reply to You need SATA drivers ...

During windows install you should see something at bottom of screen, something like
"Press F6 to load special/other drivers"....(you ahould have previously copied these sata drivers to a cd rom or floppy) point to where you installed the SATA drivers then Windows will allow install on the SATA drive.

Collapse -

RE: "install on the SATA drive" ...

by OldER Mycroft In reply to Previous post about drive ...

As I mentioned to the other bloke in this thread, the OP already has a working XP install - but it's running from an IDE HDD.

Everyone is assuming the SATA drivers are so that XP will install - not so in this case - XP's already installed.

Collapse -

SATA Drives

by merced.a In reply to Previous post about drive ...

Thanks, yes I did that.windows did installed but it crashes once the systems tries to come up.It crashes the moment windows comes to the point of starting. I must need the original windows cd that came with the system.

AM

Collapse -

BIOS

by Mohammad Oweis In reply to win Xp installation, does ...

Find in the BIOS configuration an option regarding SATA Native Mode, or anything related to SATA operation (name is different for each BIOS vendor) then disable it, or change it to the other value.

After that try to install Win-XP, now it should see the drive.

Collapse -

RE: "After that try to install Win-XP" ...

by OldER Mycroft In reply to BIOS

Umm - the OP already has XP installed on an IDE HDD.

Collapse -

Well...

by Mohammad Oweis In reply to RE: "After that try to in ...

I did not notice that you are trying to add the SATA drive as an additional one, and windows is installed on the IDE drive.

Anyway, Windows-XP can not see SATA drive that run on native mode or with ACHI enabled from BIOS.

If its already enabled, disable it, then go to Computer Management -> Disk Management -> Right click -> Rescan disks.
Theoretically this should work :)

Back to Hardware Forum
8 total posts (Page 1 of 1)  

Hardware Forums