General discussion

Locked

windows nt 4.0 software

By raw280 ·
I am running windows nt 4.0 at this small charter hs. The software now starts up and gets to the blue screen that indicates the windows nt and then the screen just goes blank. The computer continues to run but I see nothing on the screen. It doesnot go any further then that now. How can I fix this problem? And if the software is corrupt how can I save all of the inofrmation on the HD is i have to reinstall

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

windows nt 4.0 software

by robwagner In reply to windows nt 4.0 software

1. When you re-boot, select 'last known good'. See if that allows you into the system.

2. Select VGA mode when re-boot after #1 fails. See if that allows you into the system.

Q: Do you have NTFS partitions on your hard drive?

A: If so, you will need to find an application on the web that allows you to boot with a boot disk and read NTFS formatted drives.

Good Luck!

Rob

Collapse -

windows nt 4.0 software

by raw280 In reply to windows nt 4.0 software

The question was auto-closed by TechRepublic

Collapse -

windows nt 4.0 software

by david.slater In reply to windows nt 4.0 software

Yeah youre video settings might be wrong have you been messing with the resolution becasue you may get a signal out of range error if you have the settings to high for the monitor. I am sure that it is down to your video settings

Collapse -

windows nt 4.0 software

by raw280 In reply to windows nt 4.0 software

The question was auto-closed by TechRepublic

Collapse -

windows nt 4.0 software

by raw280 In reply to windows nt 4.0 software

This question was auto closed due to inactivity

Back to Windows Forum
5 total posts (Page 1 of 1)  

Related Discussions

Operating Systems Forums