Questions

Is Asus A7N8X-e motherboard Good?

+
0 Votes
Locked

Is Asus A7N8X-e motherboard Good?

dinkey
I'm starting to believe that the motherboard, Asus A7N8X-e, is a piece of junk. I've been messing with this pc for nearly 3 days trying to load a new HDD, with WinXP 32bit Home w/sp3. I've never had this much trouble before. I have a new 250gb WD blue sata hdd i'm tring to load. the bios itself does not see the hdd but the raid array sees it. I've hit F6 and loaded drivers when asked it goes through the format and copy files stages no problem but upon reboot I get BSOD stop error 0x7e. I've tried this with 2 different sata drives, different memory I've pulled everything from the board except the necessary standard stuff. (Memory Video cd drive and hdd) I've even changed the memory and CD drive. I also went back and found an IDE drive and get the same results with 2 different IDE drives. I DON'T need the pc raided. Also I just found out that the original HDD in the pc was Sata and all it would do was reboot itself. Sooo, Bad motherboard? Or am I missing something? And yes, the jumper on the mother board is set to enable.
  • +
    0 Votes
    OH Smeg

    If it starts normally the Power Supply is your culprit, a Voltage Rail can not supply enough Wattage during startup and is pulling the Voltage Low and the device is not running causing the BSOD.

    The obvious things here are HDD's or Fans causing this but it always comes back to a poor quality PS to begin with.

    Also have you looked at the BIOS Settings? Wanting to run a RAID always is a setting in the BIOS where it's been changed to RAID. It's probably better to reset the BIOS to Factory Defaults by unplugging the system and pulling the battery and while it's out checking it for the correct voltage then using a Known Good Battery and setting the Date & Time.

    Of course if the Date & Time is incorrect you'll always get a BSOD as you obviously can not load a file with a Date Stamp latter than the current Date & Time can you?

    Col

  • +
    0 Votes
    OH Smeg

    If it starts normally the Power Supply is your culprit, a Voltage Rail can not supply enough Wattage during startup and is pulling the Voltage Low and the device is not running causing the BSOD.

    The obvious things here are HDD's or Fans causing this but it always comes back to a poor quality PS to begin with.

    Also have you looked at the BIOS Settings? Wanting to run a RAID always is a setting in the BIOS where it's been changed to RAID. It's probably better to reset the BIOS to Factory Defaults by unplugging the system and pulling the battery and while it's out checking it for the correct voltage then using a Known Good Battery and setting the Date & Time.

    Of course if the Date & Time is incorrect you'll always get a BSOD as you obviously can not load a file with a Date Stamp latter than the current Date & Time can you?

    Col