Questions

Answer for:

Wired Router & Wireless Access Point problems

Message 10 of 10

View entire thread
+
0 Votes
patmcd99

Hi folks, been away for a few days so got back to base to try and sort out these routers.

I've got the wired router setup as a bridge and the wireless router with an ip address outside the wired DHCP range. PC is using maually set ip address.
The wireless router status is picking up the ISP issued ip & DNS servers etc but I still can't access the net or ping the wired router.
Should I use NAT on the wired to "open" all ports to the wireless?

Zyxel: Bridge mode RFC1483; 192.168.2.1 DHCP on range 192.168.2.2 - 192.168.2.7

WPN824: 192.168.2.100, DHCP off, IP & DNS ISP assigned, gateway 192.168.2.1

PC: manually assigned ip with DHCP range, gateway 192.168.2.1

Any suggestions would be great, thanks