General discussion

Locked

LOAD WIN95 AFTER FORMAT PACKARD BELL

By Casemaker ·
Hi,
I wanted to load win95 onto a packard bell 486 computer running win for workgroups. I looked at the recovery disks and the multimedia cd and multi media master cd and thought I was going to be able to restore the system after I fdisk and format. After doing the fdisk and format the axcel 43cd packard bell does not recognize the cd nor will it allow me to do a restore with the disks. When I try to load win95 with the win 95 setup disk it tells me that it cannot load because I already have an operating system installed. The system is a Packard Bell Axcel 43cd multimedia computer with a intel 80486dx2-50 processor at 25/50 mhz, 4mb ram 420mb hdd. Phoenix bios v4.03.
Any help would be great.
Thanks
Mark

This conversation is currently closed to new comments.

12 total posts (Page 2 of 2)   Prev   01 | 02
Thread display: Collapse - | Expand +

All Comments

Collapse -

LOAD WIN95 AFTER FORMAT PACKARD BELL

by Casemaker In reply to LOAD WIN95 AFTER FORMAT ...

Hi,
I have found the drivers for the cd rom. My problem is this. The cd is attached to a controller on the sound card and will not be recognized by the system at boot up. I am not sure where to load the drivers for the cd rom. I am unable to test the sound card to confirm that the drivers are loaded correctly. Any thoughts!!!
Thanks

Collapse -

LOAD WIN95 AFTER FORMAT PACKARD BELL

by Casemaker In reply to LOAD WIN95 AFTER FORMAT ...

This question was closed by the author

Back to Desktop Forum
12 total posts (Page 2 of 2)   Prev   01 | 02

Related Discussions

Related Forums