Cannot connect to the internet

By ron.cluck ·
I just installed a new server that runs Windows Server 2003 R2. I have connectivity to the cable modem but cannot connect to the internet. I have a Braodcom Gigabyte ethernet card in the server. I am new at this and not sure what all to install from the Server Management interface.I et the ip addresses by right clicking on the connection. When I click on the connection it even says it is connected. I hope someone can help.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Try this...

by DoubleShocker In reply to Cannot connect to the int ...

Go to Start... Run.... CMD [ENTER]

Type: ping [ENTER]

If the DNS is configured properly, you will see something along the lines of:



Pinging [ wi

Reply from bytes=32 time=25ms TTL=51......


The key is that the DNS converted to ( in this case.

If your DNS is configured correctly, let us know....

Collapse -

Cannot connect to the internet

by jlouis45 In reply to Cannot connect to the int ...

Have you checked the internet settings on the browser. Does it have an ip address and a port for accessing the internet. It looks like a browser issue if it is connected to the internet but you are not able to view the pages. Also let me know if you have a firewall. You would have to configure your firewall to access the intenet pages. Try to add the proxy or select automatically detect the settings and let me know the outcome.

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums