Cannot Enter Bios Setup after using DriveClone 2

By gsmith644 ·
Had a known-good WD400 that was cloned to a ST3250620A (also was good - at least it formatted). After 'cloning', Seagate drive non-responsive, in fact causes PC to 'hang' if attached as Master or Slave to either ID0 or ID1. This same problem occurred w/a WD1600 target drive. I've contacted Farstone tech support but they are not helpful (so far).
If I reconnect WD400 as master (only) PC boots to XP/Pro desktop. It's almost as if DriveClone2 wiped out the target drives - either the low-level mfgr formatting or ...??
Anyone have any ideas? Before you ask, hardware is biostar P4M80-M4, Award BIOS. 1GB RAM. -greg

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Share your knowledge
Back to Hardware Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums