General discussion

Locked

Changing ip address on printer

By MichaelG ·
We have a network printer that accidentally had its ip address changed to one outside our address subnet range. Now I cannot access it through telnet session in order to change it back. The reason I cannot change it on the front panel is the displayhas partially burned out and the right side is not viewable. Therefore you cannot see if the ip you are entering is what you believe it to be. To make matters worse the circuit board for this printer is no longer avaiable. It is an HP laserjet 4. Anyone have any suggestions?

This conversation is currently closed to new comments.

13 total posts (Page 2 of 2)   Prev   01 | 02
Thread display: Collapse - | Expand +

All Comments

Collapse -

Changing ip address on printer

by bmackenna In reply to Changing ip address on pr ...

It sounds, to me, like this would be a good time to replace the printer if it's in as bad a condition as you've described. You may get past this issue but what about the next issue that comes up and the one after that.

Collapse -

Changing ip address on printer

by MichaelG In reply to Changing ip address on pr ...

Poster rated this answer

Collapse -

Changing ip address on printer

by MichaelG In reply to Changing ip address on pr ...

This question was closed by the author

Back to Networks Forum
13 total posts (Page 2 of 2)   Prev   01 | 02

Related Discussions

Related Forums