Question

Locked

How can we print using GeoFrame 4.2 on Red Hat Enterprise Linux 3?

By bagheri.soheila ·
before we use this command for print "RAS" format in old version of Geoframe Software (that we installed it on workstation),
lp -d printername filename.ras
but in new version of Geoframe (VMWare) that we install it on PC, we can not used this comman,

and also we can not use these command to convert "pds" to "rst" and "rst" to "ras":
hplot: we used this command to convert "pds" to "rst"
rf: we used this command to reformat "rst" to "ras"

This conversation is currently closed to new comments.

13 total posts (Page 2 of 2)   Prev   01 | 02
Thread display: Collapse - | Expand +

All Answers

Collapse -

Reponse To Answer

by bagheri.soheila In reply to Printer Configuration in ...

I did all these steps, but I can not find printer driver for HP DesignJet 1050c it the list? It is difficult to find Linux printer driver of HP DesignJet 1050c?

Collapse -

Reponse To Answer

by bagheri.soheila In reply to Printer Configuration in ...

I could print test page,

Collapse -

Reponse To Answer

by bagheri.soheila In reply to Printer Configuration in ...

thanks you very much, you helped me so much

Back to Software Forum
13 total posts (Page 2 of 2)   Prev   01 | 02

Related Discussions

Related Forums