General discussion

Locked

Netware 5.0 and Jet Admin

By hcarlson ·
I am installing Netware 5.0 on a new Dell PowerEdge 4300 server. I can not get the HP jet admin cards in the printers to find the file server. I used Jet Admin 2.5 to set up the jet admin cards and rechecked all que names and print server names to make sure they are correct. The 4 jet admin cards worked fine on my old Compaq server using Novel 4.11. What am I doing wrong?

This conversation is currently closed to new comments.

13 total posts (Page 2 of 2)   Prev   01 | 02
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Netware 5.0 and Jet Admin

by rwscc In reply to Netware 5.0 and Jet Admin

JetAdmin is dead. Version 3.43 was the last release. Get it while you can from HP's site. Now they provide WebJetAdmin, which may or may not work for you. Hp has also released a "Network Printer Installation Wizard." I really recommend it's use. It will setup each PC to print directly to the JetDirect using IP protocol. It eliminates all the nasty admin problems of print queues. Dealing with the user that just ran a volume out of space because they had no idea that a twenty page report withcolor bar charts would take a couple hundred meg when they set the print quality to maximum, enough to make you scream! But by using the HP network printer install the only thing that fills up is their one hard drive.

Collapse -

Netware 5.0 and Jet Admin

by hcarlson In reply to Netware 5.0 and Jet Admin

Poster rated this answer

Collapse -

Netware 5.0 and Jet Admin

by hcarlson In reply to Netware 5.0 and Jet Admin

This question was closed by the author

Back to Networks Forum
13 total posts (Page 2 of 2)   Prev   01 | 02

Related Discussions

Related Forums