General discussion

Locked

ram

By tRippin ·
Do i have to set the jumper setting on the motherboard when i add a new piece of ram 128 pc 133 to my current 64 meg ram ? which is running on PEntium 600
wealsoft computer .. or is it just plug and play?

This conversation is currently closed to new comments.

Thread display: Collapse - | Expand +

All Comments

Collapse -

ram

by tRippin In reply to ram

Poster rated this answer

Collapse -

ram

by DIMM In reply to ram

RAM= Radium Access Memory
SDRAM= Sychrous Dynamic

Ok With Ram SD Runs DIMM
DIMM Is A Memory Module Thats 168Pin
IF You Have Enough DIMM Slots To Place A 128 SD Pc133 Block Then Its Fine And It Should Work If You Put The New Ram In And It Doesnt Read The Ram At The POST (Power On Self Test) Then Theres Either Something Wrong With The Ram Or The Computer

But If The Ram You Put In Doesnt Read Like EG Current: (64mb SDRam 168 PIn DIMM) 6549593
12884739 At Test This Aint Correct Test Numbers But Its And Eg If Theres No Beep Codes Then Theres Something Serious Wrong


Goodluck

NEED MORE HELP TRY Dualinlinememorymodule@hotmail.com (Messenger)

Collapse -

ram

by tRippin In reply to ram

Poster rated this answer

Collapse -

ram

by chocotechstuff In reply to ram

No need to set a jumber since you have a Pentium 600 this is a plug and play, provided some of the setting you should follow like other branded computer there is a condition in installing memory. not like other PC just put in a series in a slot thenit will be detected already.

Collapse -

ram

by tRippin In reply to ram

Poster rated this answer

Collapse -

ram

by tRippin In reply to ram

This question was closed by the author

Related Discussions

Related Forums