Discussion Locked

About windows 2000

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I installed windows 2000 prof. on 1.2 GHz system with 810E motherboard and then i replace system hard disk and put it in 1.7 GHz system with 845 motherboard but when i start my w2k prof. it's gives me blue screen.Why it gives me this blue screen why w2k prof. not automatically detect another system configuration like windows 98 do.
I hope someone got my question.
Regards.
Anurag.

7 replies

by dmiles

Check the BOS,it will give you the details of what hardware is not loading properly,most likely the graphics card or nic if present is causing a conflict,reload the drivers for these two cards and see if the problem will desolve

by techkid

It's never a good idea to just 'transplant a computer', even in Win98. You need to boot into safe mode by pressing F8 when it says "verifying DMI pool". It goes by quickly so you have to have fast fingers. I usually just hammer away at the F8 key immediately following the post test.

If windows then loads you're in good shape. Go into the Device Manager and uninstall EVERYTHING in there that you can. I mean everything... Then reboot and win2k should redetect everything for your new motherboard. You'll have to have all of your new drivers handy though.

If windows doesn't load in safe mode you've got bigger issues and it's best to format and reinstall.

by cg it

what's the BSD error message? Did you add new memory?

[note:I experienced a critical stop error and mem dump upon adding 512 MB of memory to my W2K Pro box. The Error message indicated a read error on in memory. After much experimentation, what I found was; The motherboard onboard memory cache was causing read/write faults 3. the voltage to the memory modules was insufficent [3 512MB DDR DIMMS]]. Correcting the voltage output to the memory modules solved the read/write faults, disabling themotherboard cache solved the read/write faults and the system came up and ran stable. So, knowing just what the error message is will help considerably in narrowing down what the cause of the unstable system is.

This discussion is closed to new replies.