Discussion Locked

Active Directory Installation Issue

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am have a pc I am using as a test system to finish my MCSE testing. In the machine I have a 3.2GB hard drive. I partitioned the hard drive as follows: 400MB for Windows 98, 2600MB for Windows 2000 server. I have installed both O/S's just fine and both are working fine but I have tried to do a "dcpromo" to put active directory on the server and it locks up and does not complete installation every time. I thought the minimum partition size for a win2000 server was 2GB. I have tested the RAM andhard drive for problems and have found none. The only viable answer I have come up with is the partition is too small to install active directory. Wondering if I am correct in this assumption or if there is something else I am missing?

5 replies

by quintar51

The partition is small in your case, but I don't think that it's the reason for your lockup.

Do you have DNS installed and configured with a forward lookup zone? Make sure the zone is configured to allow dynamic updates.

Also, if you right-click on the server, properties, monitoring tab, is the server able to pass both simple and recursive queries?

Also, will this AD Domain need internet access?
If so, make sure you enable forwarders in the DNS server, include your ISP's DNS servers. This also means that during the DCPROMO process, make sure you select 'no, I will install and configure DNS Myself', just to be on the safe side.

If all your DNS settings are correct, you can try checking the event viewer also for other clues regarding the cause of your lockup.

by joseph moore

How much free drive space do you have on the Win2K partition? YOu do need a few hundred megs free to run DCPROMO.
Also, is the partition NTFS-formatted? It needs to be.

hope this helps

This discussion is closed to new replies.