Discussion Locked

adding a printer port to NT4

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
What is the best way to add a second printer port to a SBS 4.5 system? I tried a StarTech serial/parallel board and it froze the system.

4 replies

by timber

If your on a network I assume you are with SBS4.5. Look into either intel's intelliprint solutions or HP's Jet Direct Print Servers. You can ussualy find these on ebay or Price Watch for a reasonable price and they're pretty straight forward for installation on the network.

Just an FYI I prefer HP Jet Direct but Intels solution seems to be cheaper.

Good Luck

by net-tekkie

I've installed net printer devices before. In this case, it's a DeskJet & the interface would probably cost more than the printer. Since it's sitting next to the server, it would seem more straight-forward to just add a port.

by jewright

You should be able to get the board you have to work. You will either need to disable the on-board serial port or setup the StarTech to use Com3 so the serial port won't lock-up your sytem. Then you will need to configure your server to use the second LPT port to use IRQ 5. Run "WinMSD" on the server to see what (if anything) is on IRQ 5. You may have an audio card or NIC setup on 5 and you will have to move or remove it.

Good Luck.....Jeremy

by net-tekkie

The Star card doesn't have any jumpers--it loads a control panel device for configuration. Trouble is, the machine freezes before running it.

This discussion is closed to new replies.