Discussion Locked

adding subnets to DHCP range

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Our current network is full and I need to add a second subnet of addresses for DHCP. I have them in the Router already, and on the PDC (DHCP Server). I cannot access them when my initial DHCP pool is full. Any suggestions?

2 replies

by lusu

You need 2 network interfaces (actually 2 IPs)... assign from the DHCP configuration one range on one card and the second range on the other. Each IP must be fixed, one in the first subnet the second in the other.

The alternative is to enlarge the network range by reducing the netmask (e.g. from 255.255.255.0 to 255.255.248.0 -- this is a subnet with 8x256 addresses).

by isys

You also need to have two different physical layers. There is no way to differentiate between DHCP servers on the same wire.

This discussion is closed to new replies.