Discussion Locked

additional IP address range

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Currently we run one IP range in DHCP manager on a Windows NT4 server. We have just received a second range of IPs to use but they are not consecutive with the first. Numbers are the same in the first two number fields, in each range but the thirdand forth are different. How do I add the second range into the DHCP scopes, to allow users to access the additional IPs?

2 replies

by timwalsh

Generically speaking, much really depends on the Subnet mask assigned to the scope at the time the scope was created.

If the new block of IP addresses can be accomodated by the configured subnet mask, you can add the new block of addresses to theexisting DHCP scope.

If not, you will need to create a second scope, and then combine the scopes into a superscope.

Be advised that if you must define different subnet masks to accomodate the assigned IP blocks, there are other implications dealing with the interaction between the two subnets on the same network.

This discussion is closed to new replies.