Discussion Locked

anyone know anything about backup exec?

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running BackupExec 10d on a Dell PV-122T LTO-2 autoloader set (at the device level) for Sequential loading of media.

I have set up an incremental backup job to go onto any of seven 200Gb scratch media tapes. my job is set up with the following settings:

For "When this job begins," I've selected "Overwrite Media."

For the Media Set:

I've got "Overwrite" set to "Infinite - Don't allow overwrite."

And for "Append Period," I've got "Infinite - Allow Append."

Now, when I run this job, instead of appending all of the week's daily incrementals onto one tape (each incremental rarely gets above 20 or 30Gb and each tape holds 200Gb), it wants to put them on SEPARATE tapes. I would expect that with my media set allowing an infinite append period, it would just keep appending subsequent incrementals to the same tape, as long as room remained on that tape.

Anyone of you good techies have any suggestions as to how to get BackupExec to dump all incrementals onto ONE tape (assuming, of course, that there's room)?

BTW, I know this is possible, because my predecessor (who has since become incommunicado) had it working.

Thanks a million in advance. happy

G

1 reply

by charliespencer

Didn't you post this a week or so ago?

Try reposting this using the 'Ask a Question' button. The 'Discussion' forum is for matters of general discussion, not specific problems in search of a solution.

On the 'Questions' forum you'll find TR members who specifically seek out problems in need of a solution. You'll find more of those members in 'Questions' than here in 'Discussions'.

Additional benefits to the membership include:

1) The "Questions" forum provides for your feedback, by way of your being able to mark "helpful" responses as such. This does not necessarily mean that a given response contained the complete solution to your problem, but only that it served to guide you toward it. This is intended to serve as an aid to those who may in the future have a problem similar to yours, so that they might have a ready source of reference available, thereby perhaps obviating the need for them to repeat questions previously asked and answered.

2) The revised TR makes it quite difficult to find both "Discussions" and "Questions" that have not had a fairly recent post, owing to some functions co-mingling them in the listings. By keeping each type in their respective forums, it is easier for all to find what they are looking for.

This discussion is closed to new replies.