Question Locked

Asrock P4i65G i/o issue

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi Guys!

Noobie to thf site here! But pretty good on the old tech side! Right, question for you all:

I have just installed a new P4i65G and 2.6 P4 in my machine. Built it all up and transferred my HDD accross. Now I KNOW what you're going to say about me having popped XP on it a-fresh...that will be my last resort at the moment!

I had a few IDE related BSOD, which I sorted by plugging in my HDD to my old mobo and changing the controller drivers to the standard ones. Now, once I did that, I then loaded up to the login window of XP Pro...only to find that my keyboard (ps/2) and mouse (USB) are not working at all! The they work fine on my old mobo and the keyboard is happy enough to let me navigate through the BIOS, but when it actually loads the login, it stops working, so I can't actually log in...

Now, here's the funny part: The NUM Lock light is on...but that's it. Also, if I plug the mouse in using the PS/2 adaptor, the light on the bottom of the mouse is on, but it's still unresponsive. If I use USB for the mouse, the light flickers for a couple of seconds (and is on while in BIOS) but then goes out when on the main screen.

I'm stuck! I've moved the jumpers on the ps/2 usb power pins to both positions and they still haven't worked.

Help please!! If you can sort this, I'll have your babies!!

Thanks in advance guys!

Noel

3 replies

by Former member

Go in here and delete any drivers that relate to either the keyboard or mouse. If possible use a PS\2 mouse to do this as the usb drivers will not be loaded yet. When done reboot your computer and go into the bios, look for the usb section and make sure "Legacy" is marked "Enable",, then press the "F10" key on your keyboard and confirm the settings by pressing the "Y" (for yes) key. Now your computer will boot up, When in, load on any drivers for your motherboard (that is why the mouse did not work, no motherboard drivers.). Make sure that your keyboard is of the PS\2 type to begin with, once the usb ports are ok then you can shutdown and connect your usb devices.

Please post back if you have any more problems or questions.

by oh smeg

And try this

http://support.microsoft.com/default.aspx?scid=kb;en-us;824125

It should cure the problem.

The reason that the USB & PS2 ports are unresponsive is that the required Chip Set Drivers for the M'Board are not present. The fact that they work at the POST Stage means that the unit is working correctly but when the Windows Drivers get loaded the system stops working because the correct Drivers for Windows are not present.

Col

This discussion is closed to new replies.