Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi im trying to fix a hp media smart ..... when i press the power button it dose not start at all so i thought i was the atx power supply but i jumperd it and it powers up, so then i jumperd the power supply still connected to the motherboard and the computer booted up fine ..... what do you think could be wrong ????
3 replies
by rixtech Accepted solution
Clarifications
by thechas Accepted solution
If you are lucky, all that is wrong is that the push button power switch on the front has gone bad and needs to be replaced.
It might even be disconnected from the motherboard.
If the switch is good, then the circuit on the motherboard that routes from the switch header to the power supply connector has failed.
Chas
by oh smeg Accepted solution
Where the Fly Leads from the M'Board tot he Front Panel Switch had failed so when you test the switch make sure to test at the switch and again at the Plug.
Col
This discussion is closed to new replies.
Trending Laptops Forum posts
Sort by Trending
Question
which mac should take for office use
0 helpful
3 replies
Question Locked
Dell latitude 3450 Issue with Power Rail Failure
0 helpful
9 replies
0 helpful
1 reply
Question Locked
How are you backing up Microsoft 365 data in your organization?
0 helpful
2 replies
Discussion Locked
Employee Work Monitoring: Challenges, Tools & Best Practices
0 helpful
3 replies