If you have previously connected with the username and password you are using, one of the following problems could cause your password to be rejected, or prevent it from being saved.
Your password list (.pwl) file may be damaged, the Rna.pwl file may be corrupted, password caching may be disabled, automatic login may be enabled, Dial-Up networking may be damaged, or there may be registry errors.
Click on Start->Settings->Control Panel->Network
Make sure that Client for Microsoft Networks is installed. If not install it. See the relevant section in this FAQ under Dial-up Issues.
Click on Start->Find->Files or Folders.
In the Named box type your login name.
Make sure that My Computer is showing in the Location box.
Delete any files that are found with the extension or of type 'pwl'.
Restart your computer.
When your computer reboots you should get an 'Enter Network Password ' or 'Welcome to Windows' dialog box. Enter your dial-up username and password and click OK, or if you're on a Local Area Network enter your network login and password.
Click on Start->Find->Files or Folders.
In the Named box type "Rna.pwl".
Make sure that My Computer is showing in the Location box.
Delete any files that are found.
Reboot. Right Go to Start->Settings->Control Panel and double click on Internet Options. Click on the Connections tab, and make sure that the NXS or Net-Express connection is set as default. Click Settings, and put your username and password in the appropriate spaces at the bottom of the page. You should leave 'Domain' blank. Click OK back to the control panel. Try to dial in again. Make sure you check 'Remember Password'. If this dosen't work, contact support.