Discussion Locked

best way to image a win2k server partiti

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a windows 2000 server that is needs a bigger hard drive. I have one physical drive and it is partitioned into two partitions C and D.
What is the best software to use so I can image Partition C to it's own physical drive and Partition D to it's own also? I know about ghost but I've been told it does not support server, is that true. I just want to create an image of the current drive and place the data in two bigger drives. Any help would be apprecciated.

11 replies

by les

You should be able to do it with ghost. Read the article at the following link. It states that ghost does not support cloning windows 2000 when you are rolling out many servers however if you are migrating or setting up a backup then it should work well.
http://service1.symantec.com/SUPPORT/ghost.nsf/docid/1999012108164025

Good Luck.
If the link does'nt work the document id on the symantec site is 1999012108164025. Run a search on that in the knowledge base and it will find the article foryou.

by enthusiast

I have used and am using Symantec ghost to create images of any Windows partition without any problem. However, you would need a separate 32 bit partition to store the ghost image created. I suppose you can store C's on D's and vice versa, but they have to be 32 bit not NTFS otherwise ghost can't see it.

by tony

This is where drive image, by powerquest comes in.

http://www.powerquest.com/driveimage/

I find it imensely useful, not only does it read both 16bit, and 32bit partitions. It also reads, NTFS, CDFS, HPFS, to name but a few. It is very verstaile, and I would never, ever go back to using ghost after using this little beauty.

Regards,
Tony

p.s. I can provide further more extensive help on Drive Image if needed.

by bpntn

I researched both Powerquest and Symantec products at their web sites and found that neither one of them support win servers. Computer Associates has a image product that doesn't work with server also. If you do find a image product that will workwith NT and 2000 servers please let me know.

by sigmapi71

I use PowerQuest Drive Image. It's able to write to FAT16, FAT 32, NTFS and other FSs, and it writes also directly to CDR. Make boot floppies with Boot Disk Builder, boot the server and image the partitions wherever you want (CD, other partition, network). Then restore to the destination drives.

This discussion is closed to new replies.