Discussion Locked

Boot Up Errors

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My Compac computer has WINME on it. When I boot it I get the following error:
OE : 018F : BFF7B018 or
OD : 0028 : 000000003

I've done a complete step by step boot thru msconfig and determined that a specific program was causing it not to boot properly. I removed that program. Then reran the complete step by step and it booted fine for about 20 tries. Now all of a sudden it is doing it again - same error message. The system then goes into long boot, gives me options or boots into safe mode.

I can get it to boot, but I can't figure out why I keep getting this error code and don't seem to be able to find it in the white papers at MS. Can anyone help with this problem?
Thanks in advance for your help.

4 replies

by w2ktechman

scan for virus
also make sure that the associated program is not in the startup group. If it is, remove the startup entry.

by surfer64

Virus scan had produced a clean system. Program was not in the startup group. Registry had been checked and scanned for any remaining remnant files and none were found.
Problem persists - intermittantly.

by surfer64

Ran a thorough Scandisk, from windows and again from DOS Prompt. No problems found on HDD.
Problem persists - intermittantly.
When restarting, system boots normally - most of the time. After complete shutdown and hard boot, problem shows itself again with the same error code. MSCONFIG Line by Line trouble shooting checks show no problems with loading drivers or config files. Manual boot from prompt screen using confirmation of driver loads allows reboot without error.
After complete shutdown system reboots through ME splash screen then goes into error screen with error code "Windows"
OE : 018F : BFF7B018. ME help and support provides no suggestions for what this error is referring or how to fix it. White papers at MS site do not address it.
I'm looking for an answer from someone who has dealt with this particular error code and understands what it means and how to fix it.
Anybody out there?

This discussion is closed to new replies.