Discussion Locked

Booting Problem

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have P-III 750 MHZ, 128 MB SDRAM, 20 GB HDD with WIN'98 loaded on it. While loading windows at system start up, as soon as it encounters "Device=Himem.sys" line, system reboots. Fresh installation of HIMEM.SYS or Windows didn't help.

If i boot the system using step-by-step confirmation mode and bypass the "device=himem.sys" directive, it boots to command prompt without any problem but windows won't load due to non availability of himem.sys.

If I copy the HIMEM.SYS to a floppy and changethe line in config.sys to "DEVICE=A:\HIMEM.SYS", system would boot with no problem at all.

Please help. I have tried with "Load BIOS defaults" and "Load Setup defaults" in BIOS Setup but to no avail.

10 replies

by tg2

does your command in the config.sys file actually say:
device=himem.sys

have you tried instead:
device=c:\windows\himem.sys

or where ever you copy it to?
there's a suggestion at MS's support site that makes vague reference to that..

there's also reference at MS's site about not using the NOAUTO keyword in config sys or you also have to manually identify each device driver line because it won't "automatically" load them.

DOS=HIGH,UMB,NOAUTO

there is also a report ofthe HIGH keyword causing issues on an older machine.. so its possible all of these have an effect, and this is assuming you've not encountered a hardware problem.. like perhaps a bit of memory is failing, hence not loading the memory manager allowedthe system to boot..
etc.

by dmiles

This problem could stem memory problem,try reseating the memory to see if this solves your problem,on the other hand you may have a bad memory module,which may need replacing,try another module if possible before purchasing

by b_pope

Their sould be two lines in your config.sys

DEVICE=C:\WINDOWS\HIMEM.SYS
DEVICE=C:\WINDOWS\EMM386.EXE

just copy & paste

by akumarjain

I alread have these line in ,my config.sys and even if I didn't, windows 98 will try to load Himem.sys on it's own

by learn4ever

I'm not confident aobut issues with Win98, but on my home machine with WinME, I don't have anything in my config.sys....period! It's not required with WinME and perhaps not with 98 either. I have no reference to himem.sys anywhere in my system filesused at boot-up. It's been that way ever since I've run this O/S and I have no memory problems at all.There is one registry key on my machine which references himem:

HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows\CurrentVersion\MS-DOSOptions\Himem

...that's it. 98 might be different though. And if you're running any older DOS apps that line you mention will need to be in config.sys and execute correctly, of course.

BTW - I have 512MB of RAM and you'll see many people reporting that ME doesn't like anything above 511MB of ram...I don't know where this info came from, but I suspect it's wrong.

by akumarjain

win98 do require Himem.sys and either you load it thru config.sys or win98 will autoload this file.

This discussion is closed to new replies.