Discussion Locked

Building a DNS server

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ok - here goes. I need to build a DNS server in an existing network. This will be a Win2K server on a new server. I will be using AD.

What is needed to build a DNS server? THis is my weak point, so all help is requested. I do not need hardware, just info on what to put where...Sites, and whatever..

Thanks so much for the help

3 replies

by jose_12650

If you have a DHCP console, click on it and on dropdown box right click Server Options, click configure option, General Tab slide to 006 enter your DNS Server name and its IP Address, or you may choose to click Resolve. Be sure that this is the only DNS you have and that you do not have any DNS configured at Scope Options.

If you have an existing DNS, go to the DNS console, right click the computer that is serving as DNS server, then on Interfaces Tab you may choose all IP addresses or limit them to the original IP address of the existing DNS and add new DNS server IP address that you were trying to set up. But you have also to perform the steps required in the first paragraph of this comment.
I hope this will help you.

This discussion is closed to new replies.