Discussion Locked

Cable Ends

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
While troubleshooting a variety of sporadic problems in a lab, I noticed a variety of cable terminations. Some were type A, some type B, three others were not a standard type at all. Further inspection revealed the wall mounts to be type A going to the switch with type B patch cables from the PC to the wall mount box. Our system mostly uses type B but some older configs are type A. Could this be a sufficient cause for random, otherwise unexplainable timing and data errors in using lab programs? Input appreciated.

1 reply

by radiic

Both 568A and 568B wiring schemes are conformant to the 568A Wiring standard.

As long as the A or B is consistent on both ends of the cable run. Patch Panel B and wall jack type B is fine. And both being A is fine. But A at patch and B at Walljack is not. The only difference in the 2 wiring schemes is the color assignment to the pins. It is highly recomended that you choose a scheme and stick to it though. Tough to do when you come in behind someone else, I know from experience.

Now things to look for are.
Does the cable run go accross electrical wires or florescent ligting. What is the quality of the cable used. Does it have good shielding. All this can bang your crosstalk and EMI values to the roof. Try repunching the ends at the patch panel and the wall jack. Maybe the person who did the runs was in a hurry. But i would still look at other things before blaming the wire. Maybe you are using a hub instead of a switch, and this program doesnt op well in a collisiondomain. Maybe you have a mix of 10Bt and 100Bt. I would start there first.

I have seen some wire in some pretty bad condition, and stood there scratching my head wondering how it still worked. If i were you look else were.

Rad

This discussion is closed to new replies.