Discussion Locked

Can Not see COM or LPT1 ports in WIN98

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

In windows 98 printing to a local HP Laserjet locked up the PC and now
I can not see either com ports or LPT1 in the device manager. Can not print or reinstall print drivers because LPT1 does not exist. Find new hardware does not find anything. Add LPT1 will add it under device manager, but it will show it doesn't work. The modem on COM1 Works!? Reinstalled win98, same situation. Regclean, windows update, scandisk and antivirus scan, and no difference. Hardware is 2yr old Compaq deskproEP. I don't want to wipe the PC because it has a ton of customized programs. Any one know of a fix?

15 replies

by fierygod

Have you tried going out to the CMOS setup and looking to see whether the hardware port exists, and what type it thinks it is? If the hardware don't know its there, chances are that windows don't either. I'm a bit rusty on Compaqs, but if I remembercorrectly you hit the F10 key when the white square is flashing in the upper left corner during bootup, before windows starts.

by hyperplasma

Of all the damn things, someone enabled security on LPT1 and the COM ports. Needless to say I now password protected setup. Somebody wasted a lot of my time.

by spydergst1

If above answer does not work then:
Go to system\device manager tab\double click my computer. verify there are no I/O and IRQ conflicts between LPT1 and another device. check properties of device also. In the resources tab it will state if there isa conflict with another device. If so change the device or LPT1 resources.

by wits

Assuming the printer still works.(tested on another pc)
You have checked the CMOS settings and all is well.
Windows should load and device manager will display any faults. Sysinfo in system tools will inform you of any conflicts.
Nortons has a simple Diags program that runs in dos and will pick up a hardware fault.
If and it sounds like a hardware problem a com/prt pci card will do the job.

by wits

Assuming the printer still works.(tested on another pc)
You have checked the CMOS settings and all is well.
Windows should load and device manager will display any faults. Sysinfo in system tools will inform you of any conflicts.
Nortons has a simple Diags program that runs in dos and will pick up a hardware fault.
If and it sounds like a hardware problem a com/prt pci card will do the job.

by baziite

First delete the LPT1 port in device manager and shutdown / unplug the PC . Then open the cover and check if the LPT port is attached to the board or does it have a Ribbon Cable running from the board to the port .IF it is a ribbon then you should detach it from the mother board and blow air on it to clean it then re attach the ribbon and restart the computer . Windows should recognize it now as new hardware and install the drivers for it . If it still doesn't you probably have to replace the parallel LPT1 port . Also I don't know if your PC and printer support USB . If yes then you attach them to the USB port .

Good Luck !

by adriano_macri

boot into safe mode and delete lpt1 port along with com1. Check device manager to make sure there are no conflicts. Reboot the PC in normal mode and it should find the LPT1 port along with Com1.

by ddtnm

go to your printer driver folder and remove
all print drivers that in that folder and
then reinstall win 98 with your printer not
connected. when your computer restart after
the installation reconnect your print, and
reinstall your printer driver.

This discussion is closed to new replies.