Discussion Locked

Can WEP enabled PC connect to non-WEP AP

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Forgive the ignorance that this question highlights. I understand the basics of enabled WEP on a wireless NIC and AP. Is it possible for a WEP enabled NIC to sucessfully connect to a non-WEP enabled AP? If so, what type of info would the AP record for the client that connected in such a fashion? (MAC address etc.)Would it be possible to access the client directly from the network that the AP is attached to? The issue comes about with a PC (company A) being able to conenct to "Company B" networksince they don't have WEP enabled. Obviously "Company B" should correct this but is there any potential harm in "Company B" accessing "Company A" 's PC?

Thank You

3 replies

by dustyd

Since no answers have posted yet, I'll give it a stab...are you sure you're connecting to another Co.'s AP?
It would prob. be possible to connect if yours is set to "Both" Open and WEP systems, and your SSID is left to the default, and the other Co's is also, with the same vendor's AP.
As far as information, I would say that the MAC and possibly the IP address is all that would be captured.
I would venture to guess that if you can access their network AP, then any shared folders on your PC would be visible, also. (Best to setup password protection, or really configure your wireless card not to connect to any available AP.

by Former member

This reply helped a little but.

by Former member

This question was closed by the author

This discussion is closed to new replies.