Discussion Locked

Cannot make ERD /moved page file

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

After adding 256 SCRAM to a Dell 2300 server and moving the page file onto a disk other than the system disk, I can no longer make an ERD. Process ends with cannot work with the media, could not format disk, try another disk.....
I tested the floppy drive and disks on the server saving notes to the media then reformatting. Drive working fine.
Anybody got any ideas?
Surely moving the page file has not caused this? The server's running great.

2 replies

by curlergirl

I"m not sure about this, but it seems to me that if you have no pagefile at all on the system disk, this might cause a problem with some system-related procedures and the rdisk process could be one - I personally have never configured a system disk with absolutely NO pagefile, so I can't testify to this. But I would try putting a small (64MB or so) pagefile on the system disk anyway, and give it a try again. Hope this helps!

by ctmoore1998

Yes moving the page file could cause this problem. As the system requires a page => than installed RAM on the boot drive to create a dump in the event of an error. The ERD process may be tied to this in some way. Create a page file on the boot partition = or slightly greater than installed RAM and retry making the ERD.

This discussion is closed to new replies.