13 replies
by thechas
First, does the Sony show up properly as a CD drive?
Does the BIOS recognize the drive?
If not, you may need to enter BIOS setup and enable the proper IDE channel.
If the drive does not show up properly in Windows, you may need to update the IDE driver for the chip-set on the motherboard.
Further, if a DOS mode CD driver is installed, it can inhibit the new CD drive from functioning properly.
Unless you NEED DOS mode access I recommend against having ANY CD-ROM driver loaded from Autoexec.bat or Config.sys
Next, what are the specs of the PC?
And, does it at least meet the minimum requirements for the software?
How is the CD drive connected?
Is it the primary slave?
Or is it on the secondary IDE channel?
Are any other drives on the same IDE cable?
Is the drive connected to the main IDE controller on the motherboard?
Or an alternate IDE controller.
Some extra IDE controllers on motherboards and plug-in cards do not handle CD drives well.
Chas
by thechas
64MB is the minimum amount of RAM required. I recommend adding at least another 64MB.
Is the CPU at least 400MHz?
Next, check for software updates.
Sony lists a few:
http://sony.storagesupport.com/cdrw/crx230adwn.htm
Remove any spaces from the pasted link.
Chas
by phi_alpha_nu
Poster rated this answer.
by phi_alpha_nu
by oz_media
by phi_alpha_nu
Poster rated this answer.
by chris910
by phi_alpha_nu
Poster rated this answer.
by jschein
by phi_alpha_nu
Poster rated this answer.
by aquaris
Just a thought
Have you tried any other Cd burning software Like Nero ....or easy Cd creator...
If you have WinXp....then it has a Burner built right into it...No need for any other ...
just drag and drop your files...on the Cd Icon in the My computer appelet....will do the trick..
hope it helps...
by phi_alpha_nu
Poster rated this answer.
by phi_alpha_nu
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending