Discussion Locked

CD ROM / A: drive unavailable in Win98se

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi!
I have a perplexing problem concerning a machine running a VD133Pro Motherboard (IWill brand) and WIndows 98SE. The CDROM and A drive are available and work fine if I boot to DOS, but they do not appear in My Computer under Windows 98. I have checked the BIOS settings and can find nothing that would prevent them from running under Windows. Also, In Control Panel>System it says that C drive is running in compatibility mode. This is a fresh installation of Windows 98SE with no additional applications installed. Any ideas what may be causing this strange behavior? thanks in advance for the help!

RockLobster

3 replies

by thechas

First, you will usually get faster response to technical questions if you post them in the Technical Q&A section.

What you need to do, is install the IDE buss driver for the chip-set on the motherboard.

You can either copy the files from the CD in DOS mode, or download the latest version from IWill's web site.

The native W98 IDE drivers no longer can support most of the newer chip-sets.

As to compatibility mode, the missing IDE driver may be the cause, or, if you installed the DOS driver for the CD drive, it can cause this problem.

I have not installed the DOS mode driver for a CD drive since W95. Unless you run DOS applications, you do not need (or want) the Cd driver loaded from autoexec.bat or config.sys
(for most systems, both files should be empty)

What I have started doing when I set up a system, is mount the system's drive in my hot-swap bay, and copy the Windows CD and ALL device drivers onto the drive.
Then, I install Windows directly from the hard drive. When drivers are needed, I can direct Windows to the proper folder.

You never need to insert the Windows CD, or change CDs to install drivers.

Chas

by krke

What is a system's hot=swap bay, and how do you copy the Windows CD and ALL device drivers onto the HDD?

Thanks,

krke

by abdrahim

Have you looked in the Device Manager to see if their is a problem identified there? Did you refresh the bios by way of the jumper on the board, then select the Setup Defaults?

This discussion is closed to new replies.