Discussion Locked

CD Rom drive not showing

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Win XP Pro
Asus A7N8X mobo
Lite-On LTR-401255

I have just changed my motherboard to the above. Everything works fine but my Lie-On CD Rom does not show up in "my computer". When I look in devise manager it is not there. I run the "Scan for hardware changes" and it shows up and works. BUT... when I reboot it disapears again and I have to scan for it everytime I turn the PC on.

I also have a Pioneer DVD ROM DVD-106 installed but not on the same cable. The hard drive is also on the same cable as the Lite-On CD Rewriter.

It shows up in the boot up before windows runs, every time. Any ideas?

Thanks, John

6 replies

by Member 32254067

have you check to see if the drives are picked up in the bios? i would check at that level and make sure the ide knows there is a device for that chain in IDE.

by john everett

"It shows up in the boot up before windows runs, every time."
What I meant by that was, Yes it shows up in the bios

by thechas

Try this;

From device manager, remove ALL 3 IDE controllers
Primary
Secondary
Root

Shut down and re-boot.

Windows should find the IDE controllers and install the correct drivers.

If that does not fix things, download and install the latest motherboard drivers from either Asus or nVidia.

Chas

by john everett

Ok, did as you suggested and removed the IDE controllers. Rebooted and still had exactly the same fault. Thanks anyway :-(

I looked at the site for upgrades but it seems I have the latest drivers anyway. Thanks again for the suggestion.

by john everett

A chap at work (total amateur) suggested this and it worked!! :-)

I removed the cable (the one with the red stipe) joining the LITE-ON rewriter with the Hard disk.
I removed the cable connecting the DVD drive (on it's own)

I changed the jumpers making the DVD the master (which it was anyway) and the rewriter the slave and joined them on the same cable. I then made the hard drive the master and connected it with it's own cable. Rebooted and it worked!!

Happy me :-)

Thanks for all your suggestions though, no doubt I'll be back with more problems for you to solve :-)

John

This discussion is closed to new replies.