Discussion Locked

CD Rom won't read in Windows 2000

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am operating in Windows 2000 and the cd rom drives will not read the disk. The disk drive does show up in My Computer. I have a cdr and a dvd drive.

7 replies

by timwalsh

It won't read a specific CD, or it won't read any CDs? Is the CD a commercial (purchased) CD, or a CDR/CDRW?

If it is just one specific CD that can't be read, I would suspect that it is a CDR or CDRW that was created on another computer. If a CDR or CDRW is burned but the CD is not finalized, it will ONLY be able to be read by the CD drive that originally burned it.

Hope this helps.

by thechas

If this is true for ANY CD, you need to force a re-install of the IDE buss-master driver for the chip-set on the motherboard.

Start by deleting ALL 3 IDE controllers in device manager.

Restart Windows, and the new hardware wizard should take care of things.

Otherwise, you need to identify the system or motherboard, and download the latest IDE driver for it.

If this is a name brand system, you should be able to download the drivers from the mfgs web site.

Or, you can use the ID tools at either www.wimsbios.com
or www.motherboards.org
to identify who made your motherboard.

Download the W2K driver from them, and install per the instructions.

Chas

by skloo77

verify the issue by reading from dos.

boot up the system to dos. not command prompt.
then navigate to the cd-rom and do a 'dir' to see if the contents of the disc can be displayed.

if yes, reinstall your ide.
if no, pray to god, there could be some fault on your cd-rom.

This discussion is closed to new replies.