Discussion Locked

CD-RW has disappeared

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was scanning with my HP 3200 C which had been working fine, and the document that I was scanning stopped at about 18 percent. I was not able to bring the scan program up again. I uninstalled it and now I can't reinstall it. I found that my icon on the "my computer" screen for the CD-RW was missing. It is not listed on the Device Managers screen either. It is the Adaptec Easy CD Creator ver 4.0. Now I can't install the CD-RW either. I did not uninstall it, and thought I'd better get some help before I dig the hole deeper.

Running Win98SE and HP 6630 computer. HELP!

Warren

jj

11 replies

by bob.schaefer

what do you mean that you can't install cd-rw ? try reinstalling the drivers for the cd-rw else check for virus

by csmith

When your Scanner and your CD-RW quit at the same time this is usually not a hardware problem.
This usually is a virus.
The scanner is connected to the printer port, and the CD-RW is IDE.
They have virtually nothing in common.
That points to a "Christmas Virus".
The viruses hide until a specific day and time, then they strike. (Also called Trojans)
Trojans are hard to find.
Norton will find about 92% and McAffe will find about 95%.
Make sure you have the latest DAT file for the Antivirus program.
If necessary, run both, one after the other.
Regards, Chris

by rawright

Win98 is a resource hog, and some processes tend to eat up memory, especially scanning documents and images. Not all drivers are well behaved and when resources get low, things get corrupted; it may be a corrupt or missing driver causing this error. I've searched, and cannot find any virus known to activate on Christmas and wipe out CD-RW drives, so I wouldn't worry too much about that.

First, reboot the PC and check that the BIOS display detects the CD drive correctly. If the screen moves too fast to read, boot into the BIOS Setup and check it manually. If it doesn't appear, suspect a bad cable connection, a failed drive, or a damaged IDE controller. Remove and replace the cable connectors at both ends - this often causes a missing drive to reapppear. If it does appear in Device Manager but can't be accessed, remove it from the configuration and reboot. Win98 will detect new hardware and attempt to reinstall it. You should also, as long as you're inside the case, verify that any jumpers on the drive are installed correctly - pull them off and reseat them to clean the contacts.

You can also, using the Device Manager, remove the IDE Controller that the drive is connected to. Win98 will detect this and reinstall the drivers for the controller, too. CD-RW drives come with custom drivers - if your drive came with a CD for installing it, reinstall the software and reboot. If I recall correctly, the EasyCD Creator software won't install correctly if the drive itself isn't first installed and working, so reinstalling this software will have to wait until the device is properly installed and detected.

There are too many other tests to enumerate, depending on the configuration of your machine, but all of the above have, at one time or another, restored a missing CD drive for me.

What a rotten Christmas present - Good luck...

by warrenl

I found my trouble.

Somehow the "trouble shooting" screen had the box checked on "disable all 32 bit protected mode disc drives". I unchecked this box and everything came back to normal

Thanks to everyone who tried to help. I appreciate it.

Warren

by csmith

Thanks for the comment.
I had not seen that one before.
One more thing I will have to remember to check.
Isn't it wonderful, how many things can go wrong?
Regards, Chris

by warrenl

A little more info on that "troubleshooting screen"

To reach that screen, go to Control panel/systems/performance/filesystems/trouble shooting and there it is.

Warren

This discussion is closed to new replies.