6 replies
by dmoragne Accepted solution
by oh smeg Accepted solution
To replace the HDD with a new one before it fails completely.
But if you want to use this drive till the bitter end an run the risk of loosing permanently some or all of your Data then there are some Software Programs that Mark Bad Clusters/Blocks depending on what you want to call them. You could run one of these but as I've never had the need to use them since the old 486 DOS Days I have Absolutely No idea of which works best.
Well other than Norton's Disk Doctor of course but this is likely to cost more than a New HDD.
Col
by jessie Accepted solution
a failing hard drive run chkdsk for 23 hours and manage to work... have you tried just letting the utility run overnight? On large hard drives, with lots of corruption, it can really just take a LONG time.
Your best bet though is to copy off all the data and replace the drive.
by dmoragne Accepted solution
by rob miners Accepted solution
by rob miners Accepted solution
with the manufacturers testing tools. You could also run this
http://www.disktrix.com/DTTrials.htm
and then try running chkdsk /r again.
You can use the Hard Drive Makers Testing Utility to Test the Drive
Hitachi / IBM - DFT "Drive Fitness Test"
http://www.hgst.com/hdd/support/download.htm
Works with all manufacturers
Western Digital "Data Lifeguard"
http://support.wdc.com/download/index.asp#dlgtools
Works with WD drives only
Fujitsu "FJDT"
http://www.fel.fujitsu.com/home/drivers.asp?L=en&CID=1
Works with fujitsu models only
Samsung "hutil"
http://www.samsung.com/Products/Hard...ties/hutil.htm
Compatability unknown...
Seagate "Seatools"
http://www.seagate.com/support/seatools
Works with Seagate drives only
This discussion is closed to new replies.
Trending Laptops Forum posts
Sort by Trending