Question Locked

Cisco 2600 console connection

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

New to CCNA, trying to get my 2600 router to bootup all parameters set correctly and console cable terminated to only serial COM1 port on my PC. When I open a session and try to connect,error message is cannot connect to COM1 port, port is already in use!
However, I know this not to be true, I've checked device manager for any conflicts and nothing, only have USB ports as other ports....??
Please help if possible

2 replies

by michael kassner

Hello Rod,

I have two thoughts initially. I assume you are using HyperTerminal. Did you double check the config setting so that it matches those required for Cisco equipment?

Also have you tried using a different Com port in HyperTerminal?

This discussion is closed to new replies.