Discussion Locked

CISCO DMZ configuration

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi!

I am having a problem allowing my Web Server in DMZ to connect to Database server in Internal interface. I understand that some of you are highly expert in CISCO PIX, could you kindly give me an advice in this matter? My PIX configuration are as below. Thank you very in advance.

PIX Version 6.3(3)
。
access-list 101 permit ip any any
access-list 301 permit tcp any host 205.145.71.82 eq www
access-list 201 permit ip any any
ip address inside 192.168.0.3 255.255.255.0
ip address dmz 192.168.6.1 255.255.255.0
global (outside) 1 205.145.71.81
global (dmz) 1 192.168.6.100-192.168.6.150
nat (inside) 1 192.168.0.0 255.255.255.0 0 0
nat (dmz) 1 192.168.6.0 255.255.255.0 0 0
static (dmz,outside) 205.145.71.82 192.168.6.3 netmask 255.255.255.255 0 0
access-group 301 in interface outside
access-group 101 in interface inside
access-group 201 in interface dmz

3 replies

by bbanis2k

access-list 201 permit tcp host 192.168.6.3 host eq

static (dmz,inside) 192.168.6.0 192.168.6.0 netmask 255.255.255.0 0 0

by hamichael

Hi!

I have added following Access-List and Static entry but still not working :( Could you recommend another alternative?

access-list 201 permit tcp host 192.168.6.3 host 192.168.0.21 eq 1521

static (dmz,inside) 192.168.6.0 192.168.6.0 netmask 255.255.255.0 0 0

by hamichael

Hi!

I have added following Access-List and Static entry but still not working :( Could you recommend another alternative?

access-list 201 permit tcp host 192.168.6.3 host 192.168.0.21 eq 1521

static (dmz,inside) 192.168.6.0 192.168.6.0 netmask 255.255.255.0 0 0

This discussion is closed to new replies.