Discussion Locked

Cisco Pix 501 Resetting to Default

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Okay - I bought a used Cisco Pix 501 so I could learn - and so far the only lesson is not to buy a cisco pix. I was able to run a crossover to the box, and did change the IP to 192.168.1.1 from the default setting, at which time connection was lost.Now I can't get back in. I've changed by IP addressing range on my computer to allow me to reach it - but no luck.
I've also tried the console cable from the serial port to the console port - but still no luck.
How do I reset the cisco to the default setting, and most importantly - where can I find simple lessons online that will show me how to access, setup and configure this firewall?

Any help is greatly appreciated.

7 replies

by ann777

go to :
www.cisco.com

and input a search for "PIX Documentation" --

you should be able to find and download a PDF file for the configuration options for the PIX OS (version) that you have.

by p. dickason, cne, mcse, cca

I would suspect that once you addressed the interface, the default access list went into place. Since you have not yet configured an access list, the default list is a deny all. This is why you can no longer telnet into the router. Have you triedturning the unit off then back on? Unless you did a write mem, I don't believe it should have saved the config. In any event, you should really use the console port for configuration. Are you using the blue cable that comes with the unit? It hasdifferent pin-outs than a network cable so a regular patch cable won't work. Also the default speed is 9600 for the console port. I've had problems with hyperterm before so I would use a real communications program. Try these and see if they are any help.
Pete

by montea7

I am unsure from your post so I'll give you the two ways to reset this to factory defaults.

1) Connect your NIC to one of the PIX interfaces 1 through 4 open your web browser and in the address line type https://192.168.1.1/startup.html
when it prompts you for a password just hit enter. Hopefully one is not set and it will continue to load. Once in you will see the option to reset to factory defaults.

2)If you can reach the command line interface through the blue console cable you will see a prompt similar to pix> at this prompt type enable and press enter you will see pix# at this prompt type config t and press enter you will see pix(config)# type configure factory-default press enter and type write memory press enter. The factory defualt statement erases the running config, the write memory writes the factory default to flash memory.

I have not seen any easy online lessons, doesn't mean they don't exist just I haven't seen any. I would just buy the book Cisco Secure Pix Firewalls.

by tim2217

Well - your tips did it - I got back in using a straight thru cable NIC to Port 1 at the startup.html address. Thank you! My access permissions were set incorrectly as well, because I would get the login prompt at https://192.168.1.1/startup.html once I set my IP properties to the same subnet, however the PDM would not load and I'd get an access denied page. It seemed like a password issue until I simply removed the startup.html from the address and refreshed the same window (dumb luck I guess)- then the PDM would load! I've now adjusted the IP correctly, issued correct access permissions, and tested, tested, tested. I'm also going to purchase the Cisco SmartNet for $85/yr so I have complete assistance via their members only site and phone support, something tells me I'll need it.

This discussion is closed to new replies.