Discussion Locked

Cisco PIX Firewall: Out of box security?

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just bought a Cisco PIX 501 for my dad's home business, (basically, a few PCs on a home network). He has client information on one of the PCs, and wanted it to be protected, (as well as wanted a NAT solution for the network to share the cable modem connection). Here are my questions:

1) What (if any) out of the box modification do I need to perform to ensure that the network is adequatly protected?

2) Are their any default admin passwords that need to be changed, (I haven't logged into the firewall yet)?

3) How concerned do I need to be about future security flaws in the CISCO PIX software?

4) Is there a newbie guide for logging into the PIX for the first time? I've RTFM and still can't figure out how to SSL in via IE6. Is there a primary step I first must do? Is it even necessary for me to log in?

I had read that this was a great plug-in-and-forget firewall, but I don't want to find out there was something obvious that I failed to do....

Thanks!

1 reply

by assamite

Theres a few things that you need to do, firstly I suspect you will need to log in via a console cable that should be supplied or via the management software that should be supplied. You need to set IP address, etc here before being able to connect. This should be outlined in the config and setup book. There are always updates for the PIX firewall software being released and these will need to be got from the Cisco website and installed. Theres not really much of a nwbie guide to the PIX however once your in it should be stright foward. check the cisco tech support site for more in depth help.

This discussion is closed to new replies.